coinos-ui.git/src/routes/(app)/pos, branch master

Web flasher moves from /pos to /flash; /pos redirects there.

2026-09-22T05:49:19Z

coinos v3 takes /pos for the point-of-sale till, so the terminal flasher needs its own address. Old links keep working through the redirect. Co-Authored-By: Claude Fable 5.1 Claude-Session: https://claude.ai/code/session_01Tmfg8k5f3TbNJS34qiqHAp

pos: reset the device and release the serial port when leaving the flasher

2026-09-14T15:24:48Z

Connecting loads the esptool stub and parks the chip in the ROM download mode; only a successful flash reset it and closed the port. Navigating away, a failed connect, or a failed flash left the device looking frozen (OLED keeps its last frame, LED pin pulled up, keypad dead) with the browser still holding the port. Reset + release on component destroy and pagehide, on connect failure, and from a new Disconnect button. Co-Authored-By: Claude Fable 5.1 Claude-Session: https://claude.ai/code/session_01VMi2Y1oKPZ3TeeFmLej47y

pos: offer "Flash latest release" from a published firmware manifest

2026-09-05T03:12:59Z

Host the ESP32-C3 firmware under static/firmware (bootloader, partition table, boot_app0, app) with a manifest.json written by coinos-pos's publish.sh. The flasher fetches the manifest, downloads every part, verifies sizes, flashes them at their offsets and resets the device. The config partition is not in the manifest so credentials survive. Manual .bin upload stays available underneath. Co-Authored-By: Claude Fable 5.1 Claude-Session: https://claude.ai/code/session_014gVYGi29FjTeLdNTiutkZx

pos: hard-reset the device after flashing

2026-09-05T03:12:58Z

esptool-js leaves the chip in the ROM bootloader stub after writeFlash, so the device appeared dead until power-cycled. Pulse RTS the way esptool.py does, drop the port (the C3 re-enumerates), and show a "device restarted" message next to the Connect button. Co-Authored-By: Claude Fable 5.1 Claude-Session: https://claude.ai/code/session_014gVYGi29FjTeLdNTiutkZx

pos: refuse to flash anything that is not a valid LittleFS image

2026-09-05T03:12:58Z

The flasher hex-encoded whatever the /flash endpoint returned, so a server error body was written to devices as the config partition. Check the response status, require a 128KB image with the LittleFS magic, and surface the error above the form instead. Co-Authored-By: Claude Fable 5.1 Claude-Session: https://claude.ai/code/session_014gVYGi29FjTeLdNTiutkZx

fix imports

2026-02-10T01:20:06Z

update flash page

2025-09-27T05:21:03Z

default token

2025-09-14T05:27:49Z

pos route

2025-09-11T23:03:00Z